Your Christmas projector in rain and snow

An outdoor projector spends weeks in rain, frost and snow with a plug somewhere in the wet. The head usually copes, and the weak spot tends to be the adapter and the outlet, so this guide covers the IP ratings and the power side together.

What an IP rating tells you

An IP rating comes from the standard IEC 60529. The first digit grades protection against dust and solids, the second against water, and a higher number means better sealing.

IP44
Protected against splashes from any direction; fine under an eave, not for lying in slush
IP65
Dust-tight and protected against water jets; handles rain and a hose
IP67
Dust-tight and protected against short immersion up to 1 m; survives a puddle

A seller’s “waterproof” is not a rating. It may mean anything from splash-proof to sealed, and without an IP code you have no way to check which.

The six projectors by weather rating

ProjectorProjector headAdapter or plugTemperature range
Star Shower Ultra 9Not stated on AmazonNot statedA retailer listing gives -31 °F to 104 °F (-35 °C to 40 °C)
Govee H7073IP65, anti-UVIndoors or in an IP65 enclosure (Govee)-4 °F to 140 °F (US listing)
Govee H7071IP67Indoors or in an IP65 socket (EU listing)Not stated
GUSODOR RGB Stars“Waterproof” and frost-resistant, no IP figureNot statedNot stated
YUEGANG YG-LA-01IP65IP44 adapterNot stated
GUSODOR Double-Head SnowflakeIP65IP44 plugNot stated

The pattern is clear. Even the well-sealed heads ship with an adapter rated lower, or one the maker wants kept indoors, so the head can sit in the rain while the plug needs shelter.

Govee’s H7073 Aurora Star gives the widest stated temperature range in our lineup, in an aluminum body. Some owners report it fine in snow and ice, while others had a power adapter fail. All six sit side by side in the comparison table.

Protect the adapter first

The adapter turns household current into the low voltage the head runs on, and it is the part most likely to suffer in the wet. An IP44 adapter shrugs off splashes but not standing water or a snowdrift.

  • Keep the adapter and every plug off the ground, out of puddles and above the snow line
  • Put it in a weatherproof outlet box or under an in-use cover, or tuck it under an eave
  • Let plug connections hang downward so water runs off instead of in
  • Never wrap the projector or the adapter in a plastic bag, which traps heat and moisture

The YUEGANG and the GUSODOR snowflake both come with a 16.4 ft cord, which often reaches a covered outlet without a joint sitting on the lawn. Fewer joints in the wet mean fewer places for trouble.

GFCI outlets and outdoor cords

Plug outdoor decorations into an outlet protected by a GFCI, a ground-fault circuit interrupter. It cuts the power in a fraction of a second when current leaks to ground, which is what happens when water gets into a plug.

Most outdoor outlets on US homes have one, either built in or upstream on the same circuit; look for the test and reset buttons. Press test before you set up the display, then reset, to make sure it trips.

If you need an extension cord, use one rated for outdoor use and long enough to avoid chaining several together. The CPSC and ESFi both publish holiday lighting tips that make the same two points.

Run the cord along the edge of a bed or a path rather than across the middle of the lawn, where a shovel or a foot can catch it. Tuck it so nobody trips on it in the dark.

A GFCI that trips on wet nights is doing its job. Our troubleshooting guide covers how to find the plug that is letting water in.

Snow, frost and condensation

Snow on top of the head is mostly harmless on an IP65 or IP67 unit, but snow over the lens blocks the picture. Brush it off, and set the stake high enough that drifts don’t bury the projector.

On cold, humid nights the lens can fog. A dry, sealed unit and a short wait after switching on usually clear it, so don’t open the housing to wipe the inside.

Frost can loosen or tilt a ground stake over a few weeks, which shifts the beam. Check the aim after a hard freeze, since a laser that tips back can start reaching above the roofline, as our guide to laser safety explains.

What it costs to run

These projectors use little power: the YUEGANG lists 4 W, the Star Shower 7.5 W, the H7071 20 W and the H7073 24 W.

At 24 W, six hours a night for 40 nights comes to about 5.8 kWh. The YUEGANG at 4 W uses under 1 kWh over the same stretch, so multiply by the rate on your power bill and the total stays small.

A timer saves power and wear, and it keeps the projector off when nobody is watching. Our guide to timers, remotes and apps covers the dusk-to-dawn modes and auto-off cycles on each model.

Where to run the power

Plan the cord before you plan the picture. A spot 30 ft out on the lawn means a long run across the grass, while a spot near the porch may reach a covered outlet with the adapter tucked under the eave.

Our placement tips show how to pick a stake spot that suits both the picture and the outlet. The homepage list of things the box doesn’t tell you covers the adapter too, and our pick of the best outdoor Christmas projector weighs weather ratings alongside the picture.

For a wet or snowy climate

The Govee H7071 carries an IP67 rating, the highest in our lineup, with 20 swappable pattern discs and an app timer. It sits in the $$$ band, its adapter still belongs indoors or in a covered socket, and owners report that some units stop working early.

Questions and answers

More questions about weather and power

Can a Christmas projector stay out in the rain?

A projector with an IP65 or IP67 head handles rain, but its adapter usually has a lower rating or must stay indoors. Keep the adapter and plugs off the ground and covered, and plug into a GFCI outlet.

What is the difference between IP65 and IP67?

Both are dust-tight. IP65 protects against water jets such as rain or a hose, while IP67 also survives short immersion up to 1 m, such as a puddle.

Is a waterproof projector the same as an IP65 projector?

No. Waterproof is a seller’s word with no defined test behind it, while IP65 is a set level under IEC 60529. The GUSODOR RGB Stars, for example, is sold as waterproof with no IP figure.

Why does my projector trip the GFCI?

Usually because water has reached a plug, the adapter or a cord joint. Dry and cover the connection, lift it off the ground and reset the outlet. If it keeps tripping when everything is dry, the adapter may be faulty.

How much power does a Christmas projector use?

The listings give between 4 W and 24 W. At 24 W, six hours a night for 40 nights comes to about 5.8 kWh, and a 4 W laser uses under 1 kWh over the same period.